AEG AW8550TFGVTC Uživatelský manuál stáhnout pdf (Strana 6)

7 7

PCI "Campanil"TR 259 Analogic

Setting the clock

Press the control knob and turn clockwise.

Alarm programme adjustement

Turn the knob clockwise without pressing it in. At the end of the

programmed time an alarm will sound. To cancel it, turn the knob

to the bell.

XII

VIII

VII

III

H05 RR-F

REPLACEMENT OF THE CABLE

In case the cable is damaged, replace it in accordance with the

following instructions:

- open the box of the supply board as described on the picture

below;

- unscrew screw “A” fixing the cable;

- replace the cable with one of the same lenght and in accordance

with the features described on the table; switch the appliance

off, and close the gas tap

- the ‘green-yellow” earth wire must be connected to the terminal

“ “ and it must be about 10 mm longer thean the live wires;

- the “blue” neutral wire must be connected to the terminal marked

with letter “N”;

- the live wire must be connected to the terminal marked with letter

“L”.

Applance type Supply single-phase 220-230 V~

Type of cable section

All gas Rubber H05 RR-F 3 x 0,75 mm

All gas + electric grill Rubber H05 RR-F

3 x 2,5 mm

XII

VIII

VII

III

ELECTRICAL CONNECTION

Connection of the appliance to the power mains should be done

by a licensed electrician familiar with local safety regulations.

This appliance must be earthed by law. Before connecting

the appliance to the electrical supply, check that the earth

system in your house is working correctly.

Check that unit voltage and power, marked on the rating plate

applied on the appliance, are correct for the supply. It is necessary

that the feeding network is protected by a powerful switch able

to disconnect completely the network with a contacts separation

of at least 3 mm. Be sure that the earth wire green/yellow is

not interrupted by the switch.

Important: The wires in the mains lead are so coloured:

- green/yellow = earth " "

- blue = neutral “N”

- brown = live “L”

The wire coloured green/yellow must be connected to the terminal

in the plug which is marked with letter 'E' or by the earth symbol

or coloured green or green/yellow. The wire coloured blue

must be connected to the terminal which is marked with letter 'N'

or coloured black. The wire coloured brown must be connected

to the terminal which is marked with letter 'L' or coloured red. The

supply cable must not come into contact with any component the

temperature of which exceeds the ambient temperature by 50°C.

If a plug is used for connection, the plug to be connected to the

supply cable and the socket to which it is connected must be of

the same type (conforming to the standards). Easy access to the

plug or the switch is ensured once the appliance is installed.

Ensure that there is sufficient cable allowed for any subsequent

removal of the unit. If the plug is non-rewireable, pay attention

to the following points: the plug must never be cut by the supply

cord. There is shock hazard when this plug is inserted in a socket-

outlet elsewhere in the house. Never use the plug without the

fuse cover fitted. Referring to the pertinent spare parts, apply to

the appliance's supplier. The manufacturer declines all

responsibility for any damage to persons or things caused

by failure to observe the rules indicated above.

1 2 3 4 5 6 7 8 9 10 11 12

Komentáře k této Příručce

Žádné komentáře

AEG AW8550TFGVTC Uživatelský manuál Strana 6

Komentáře k této Příručce

Související produkty a manuály pro Sporáky AEG AW8550TFGVTC