AEG AW8550TFGVTC Uživatelský manuál stáhnout pdf (Strana 12)

Clean the cone and its slot by means of a cloth soaked with diluent.

Slightly grease the cone with the relevant grease, put it in its slot,

and turn it some times. Remove the cone again, remove the

exceeding grease making sure the gas entries are not obstructed

by grease residuals. Assemble everything carefully in the opposite

direction check the connection seal by means of soapy water.

TAPS REPLACEMENT

Act as follows: switch the appliance off, and close the general tap

open the work-top and disassemble also the control panel as

described on the previous paragraph. Unscrew screw nut D of the

gas tube supplying the burner. Unscrew screw V fixing the tap to

the bridle and remove it (see picture).

Note: Every time the tap is replaced, it is necessary to replace the

seal gasket too check the connection seal by means of soapy

water (see picture).

1 2 ... 7 8 9 10 11 12

Žádné komentáře

AEG AW8550TFGVTC Uživatelský manuál Strana 12