AEG 239D-D Uživatelský manuál

239 DFume Extractor HoodInstallation and Operating Instructions

10Wall unit mounting● Make the holes on the bottom of the cupboard, usingthe drilling template .● From inside the cupboard, insert the 4 supplied scre

11Wall mounting● Fix the drilling template to the wall.● Make 3 Ø 8mm holes in the wall 2 at points I, 1 as desired atpoints L.● Insert the three Ø

12Hood Operation● The hood is fitted with a variable speed motor. The mosteffective use of the hood is obtained by switching it on a fewminutes before

13● Never leave a cooking hob or ring on without a pot or pan ontop of it, to avoid the possibility of excess heat damaging theunit. Gas, oil or coal

146Maintenance and care● The hood must always be disconnected from the mainspower supply before beginning any maintenance work.Opening the grid● Open

158Removing the filterOpen the grid and remove the stops M to take out the filter.See Fig. 7.Carbon filter● The activated carbon filter should only be

16Warning● Failure to observe the instructions on cleaning the unit andchanging the filters will cause a fire hazard. You are thereforestrongly recomm

17AccessoriesThe following accessories can be ordered through your retailers.MKZ telescopic wall pipe outlet hose ABS120,120 mm ØSynthetic grease filt

18Service & Spare PartsIf you require a service engineer or wish to purchase spare parts,contact your local AEG Service Center, by telephoning:099

19

2Printed on recycled paper.AEG  putting words into action.

AEG Hausgeräte AGPostfach 1036D-90327 Nürnberg© Copyright by AEGH 259 245 940LI02HA

3ContentsIntroduction 4Extraction mode 4Recirculation mode 5Electrical connections 6Technical details 8Installation 9Safety warnings for kitchen unit

42IntroductionExtraction mode● The hood is supplied as an extractor unit and can also be used with afiltering function by fitting activated carbon fil

5● Move the lever L to position A  Fig. 3.● When connecting up the hood using a telescopic wall pipe,you should use an uninflammable outlet hose ABS

6Electrical connections230-240 V - using fixed power supply line with plug.(The unit should only be connected up by an authorized electrician).Your ap

7Technical detailsDimensionsHeight x Width x Depth (in cm) 13 x 89,9 x 51WeightNet: 9,0 kgGross: 10,1 kgMaximum absorbed power: 320 WMotor absorption

8InstallationSafety warnings for kitchen unit installer● When used as an extractor unit, the hood must be fitted with a120mm diameter hose.● If the fu

9● The national decree on fuel-burning systems specifies a maximumdepression of 0.04 bar in such rooms.● Hoods can only be used safely with appliances