AEG L87495XFL Uživatelský manuál

L 87495 XFL EN User manual

• The display shows this message for some seconds when:– You set a function that is not applicable for the pro-gramme.– You change the programme while

5.7 Extra rinse button 7Press button 7 to add rinsing phases toa programme.Use this function for persons allergic todetergents and in areas where the

6. PROGRAMMESProgrammeTemperatureType of loadMax. weight of loadCycle descrip-tionFunctionsCottons95° - ColdWhite and colouredcotton with normal soil.

ProgrammeTemperatureType of loadMax. weight of loadCycle descrip-tionFunctionsAnti-Allergy60°White cotton items.This programme re-moves micro-organ-is

4) The wash and spin phase is soft to prevent the creases of the laundry. The applianceadds some rinses.5) The default phase of the spin speed is rela

7. CONSUMPTION VALUESAt programme start the display shows the duration programme for the max-imum load capacity.During the washing phase the programme

2.Put a small quantity of detergent inthe main wash compartment of thedetergent dispenser. Set and start aprogramme for cotton at the highesttemperatu

The detergent compartment for the washing phase.If you use a liquid detergent, put it immediately before you startthe programme.Liquid additives compa

4.To use liquid detergent, turn theflap down.With the flap in the positionDOWN:– Do not use gelatinous or thickliquid detergents.– Do not put more liq

2.Press button 4 , the appliancestarts the countdown of the delaystart.When the countdown is completed,the programme starts automatically.Before you p

CONTENTS1. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32. SAFETY

10. HINTS AND TIPS10.1 The laundry load• Divide the laundry in: white, coloured,synthetics, delicates and wool.• Obey the washing instructions that ar

Water hardness tableLevel TypeWater hardness°dH °T.H. mmol/l Clarke1 soft 0-7 0-15 0-1.5 0-92 medium 8-14 16-25 1.6-2.5 10-163 hard 15-21 26-37 2.6-3.

11.6 Detergent dispenserTo clean the dispenser:121.Press the lever.2.Pull the dispenser out.3.Remove the top part of the liquidadditive compartment.4.

To clean the drain pump:1.Open the drain pump door.2.Pull the flap out to remove it.3.Put a container below the recess ofthe drain pump to collect the

129.Clean the filter under the water tapand put it back in the pump into thespecial guides.10.Make sure that you tighten correctlythe filter to preven

Put the drainage duct back and close thedrain pump flap.When you drain the water with the emer-gency drain procedure, you must acti-vate again the dra

Problem Possible cause Possible solutionThe appliancedoes not drain thewater.The water drain hose isdamaged.Make sure that the water drainhose has no

Problem Possible cause Possible solution Leakages from the drainpump.Make sure that the drain pumpfilter is tight. The water drain hose isdamaged.Ma

13.2 Unpacking1.Use the gloves. Remove the externalfilm. If necessary, use a cutter.2.Remove the cardboard top.3.Remove the polystyrene packagingmater

6.Put one of the polystyrene packag-ing elements on the floor behindthe appliance. Carefully put downthe appliance with the rear side onit. Make sure

1. SAFETY INFORMATIONBefore the installation and use of the appliance, careful-ly read the supplied instructions. The manufacturer isnot responsible i

12.Put the plastic caps in the holes.You can find these caps in the usermanual bag.WARNING!Remove all the packaging andthe transit bolts before you in

13.4 The inlet hose20O20O20O45O45O45O• Connect the hose to the appliance.Turn the inlet hose only left or right.Loose the ring nut to set it in the co

With the plastic hose guide. • On the edge of a sink.• Make sure that the plastic guide can-not move when the appliance drains.Attach the guide to the

You can extend the drain hose tomaximum 400 cm. Contact theservice centre for the other drainhose and the extension.14. ENVIRONMENT CONCERNSRecycle th

34www.aeg.com

ENGLISH 35

www.aeg.com/shop132927671-A-042013

• If the supply cord is damaged, it must be replaced bythe manufacturer, its service agent or similarly quali-fied persons in order to avoid a hazard.

Water connection• Make sure not to cause damage to thewater hoses.• The appliance is to be connected tothe water mains using the new sup-plied hose-se

Water supply pressure Minimum 0,5 bar (0,05 MPa)Maximum 8 bar (0,8 MPa)Water supply 1) Cold waterMaximum load Cotton 9 kgSpin speed Maximum 1400 rpm1

4.1 Accessories1 2341SpannerTo remove the transit bolts.2Plastic capsTo close the holes on the rear sideof the cabinet after the removal ofthe transit

5Delay start button 6Time saving button 7Extra rinse button 8Stains/Prewash button:Stain Prewash 9Spin button 10Temperature button 5.1 AUTO Off button

No Spin symbol1)Rinse Hold symbol1) Only available for Spin/Drain programme.CPrewash phaseWashing phaseRinses phaseSpin phaseThe phase symbols• When a