AEG KVH 32 Instalační příručka stáhnout pdf (Strana 13)

Follow the steps below to wire the switchplate.

a. Connect the antenna’s power/data cable to

the switchplate’s power/data connector and

lock in place (see Figure 21).

b. Crimp the supplied terminal connectors onto

the power supply’s DC power wires.

c. Carefully push the connectors onto the

switchplate’s input power terminals

(see Figure 21).

NOTE: Strain-relieve the wires to ensure a reliable

connection.

d. Connect the AC power cord to the power

supply. Then plug the power cord into the

vessel’s AC power.

e. Linear only:

Skip to “Mount the Switchplate” on page 16.

100-240 VAC

To Vessel AC Power

Power Supply

+15 VDC

(Red)

Ground

(Black)

AC Power Cord

Power/Data Cable

From Antenna

Figure 21: Switchplate Wiring (KVH Power Supply Shown)

CAUTION

For your own safety, disconnect vessel power

before you connect any power wires. Test the

circuit to ensure no power is present.

The TracVision antenna requires a stable

12 VDC (4 amps continuous) power supply.

Circular systems include a 15 VDC (4 A)

power supply; linear systems do not.

However, a power supply with a European-

style power cord is available for purchase

from KVH (KVH part #72-0312-01).

IMPORTANT!

Wire the Switchplate

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Žádné komentáře

AEG KVH 32 Instalační příručka Strana 13