AEG KFA58SIO Uživatelský manuál Strana 15

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 24
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 14
7.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also
three digit letter code for the glass
ceramic (it is in the corner of the glass
surface) and an error message that
comes on. Make sure, you operated the
hob correctly. If not the servicing by a
service technician or dealer will not be
free of charge, also during the warranty
period. The instructions about the
Service Centre and conditions of
guarantee are in the guarantee booklet.
8. INSTALLATION
WARNING!
Refer to Safety chapters.
8.1 Before the installation
Before you install the hob, write down
the information bellow from the rating
plate. The rating plate is on the bottom
of the hob.
Serial number ...........................
8.2 Built-in hobs
Only use the built-in hobs after you
assemble the hob into correct built-in
units and work surfaces that align to the
standards.
During installation in combustible
matter, NIN SEV 1000 and fire protection
guidelines and regulations of the
Association of Cantonal Fire Insurance
shall be strictly adhered to.
8.3 Connection cable
The hob is supplied with a connection
cable.
To replace the damaged mains cable
use the following (or higher) mains
cable type: H05V2V2-F T min 90°C.
Speak to your local Service Centre.
8.4 Electrical connection
Install the hob with a socket supply line.
If there is no socket supply line, the fixed
home electrical system must include an
isolating device with at least a 3 mm-
contact separation to enable a
simultaneous and all-pole cut off from
the mains (according to NIN SEV 1000).
8.5 Attaching the seal to the
rabbet
1. Clean the rabbets in the worktop.
2. Cut the supplied seal stripe into 4
stripes. The stripes must have the
same length as the rabbets.
3. Cut the ends of the stripes at an
angle of 45°. They should fit in the
corners of the rabbets accurately.
4. Attach the stripes to the rabbets. Do
not extend the stripes. Do not bond
ends of stripes one over another.
After you assemble the hob, seal the
remaining gap between glass ceramic
and the worktop with silicone. Make sure
the silicone does not get under the glass
ceramic.
8.6 Attaching the seal
1. Clean the worktop around the cut
out area.
2. Attach the supplied seal stripe to the
lower edge of the hob along the
outer edge of the glass ceramic. Do
not extend it. Make sure that the
ends of the seal stripe are located in
the middle of one side of the hob.
3. Add some mm when you cut the seal
stripe to the length.
4. Push the two ends of seal stripe
together.
ENGLISH
15
Zobrazit stránku 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Komentáře k této Příručce

Žádné komentáře