AEG 115 D Servisní příručka

BEWS18-115 XBEWS18-125 XOriginal instructions

1012312

1112312For Separating!

12123

13123

1412Accessory

1512

16STARTSTOPSTART/LOCKSTOP1122

1730°

18STARTSTARTSTOPLLOLine Lock Out Function123456Line Lock Out Function

19If the control lamp is lit: The restart cut-out is active. The machine will not start if the battery is fi tted whilst the machine is switched on. Sw

2

20STARTSTOP12Overload Protection

21The control lamp fl ashes:To protect the tool, please let it continue rotating with no-load, or reduce the load until the protection: if the motor is

22 BEWS18-115 X BEWS18-125 X...18 V ... 18 V...9000 min-1 ...

23m) Do not run the power tool while carrying it at your side. Accidental contact with the spinning accessory could snag your clothing, pulling the ac

24For accessories intended to be fi tted with threaded hole wheel, ensure that the thread in the wheel is long enough to accept the spindle length.For

To obtain the longest possible battery life remove the battery pack from the charger once it is fully charged.For battery pack storage longer than 30

FIXTEC NUT STANDARD OUTER FLANGE NUT Recommended for use with flat cut-off wheels up to a maximum thickness of 6mm Recommended for use with depressed

3Important!It is essential that you read the instructions in this manual before operating this machine.Subject to technical modifications.

4910181214

5861716STARTSTOP

6click1212Remove the battery pack before starting any work on the machine.

775-100 %50-75 %25-50 %0-25 %

8123

91 230°30°0°60°60° click